VTube-LASER Training Agenda

From ATTWiki
Revision as of 16:05, 28 September 2017 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo 1.96.png

Vtl screen hd scanner without logo.png

Contents



About the Training Agenda

Training agendas for VTube-LASER usually follow the pattern shown below.

We often adjust the training depending on the customer's application needs.


Number of Students

The fewer the students, the faster training goes. In the steps we show below, many of the actions are hands-on practice. If we have 3 trainees, then the step will require 3 iterations. If we have 5 trainees, then the step will require 5 iterations. Having too many students in the hands-on training may limit how much information we can give.

Typical Training Agenda

Day 1

STEP INSTALLATION / TRAINING TASK
1

Arm installation and setup

2

Bender integration assistance

3

Probe and scanner calibration

4

Setup a program from solid model

5

How to setup a program from a print

6

Arm connection and scanner setup

7

Measuring Cut Planes (measuring the table surface)

8

General measuring setup (set your default tolerances into VTube-LASER)

9

How to measuring the tube/pipe

10

Understanding the inspection results to qualify the tube shape

11

Using BENDER SETUP to connect to benders for setup and correction

12

How to view reports

13

How to reverse-engineer a tube

14

Address any unique application needs

15

Hands-on practice for students


Day 2

STEP INSTALLATION / TRAINING TASK
1

Review what we learned on day 1 - quiz the trainees

2

Practice full corrections loops with actual customer parts

3

Review special application needs




Other Pages