Difference between revisions of "VTube-LASER Training Agenda"

From ATTWiki
Jump to: navigation, search
(Typical Training Agenda)
(Day 2)
Line 53: Line 53:
  
 
=== Day 2 ===
 
=== Day 2 ===
1 - Review what we learned on day 1 - quiz the students<br><br>
+
1 - Review what we learned on day 1 - quiz the trainees<br><br>
 
2 - Practice full corrections loops with actual customer parts<br><br>
 
2 - Practice full corrections loops with actual customer parts<br><br>
 
3 - Review special application needs
 
3 - Review special application needs

Revision as of 15:48, 28 September 2017

Vtube-laser logo 1.96.png

Vtl screen hd scanner without logo.png

Contents



About theTraining Agenda

Training agendas for VTube-LASER usually follow the pattern shown below.

Keep in mind that we adjust the training depending on the customer's application needs. So the agenda shown below may be adjusted if necessary.

Typical Training Agenda

Day 1

1 - Arm installation and setup

2 - Bender integration assistance (Note: Steps one and 2 may take an hour or two)

3 - Probe and scanner calibration

4 - Setup a program from solid model

5 - How to setup a program from a print

6 - Arm connection and scanner setup

7 - Measuring Cut Planes (measuring the table surface)

8 - General measuring setup (set your default tolerances into VTube-LASER)

9 - How to measuring the tube/pipe

10 - Understanding the inspection results to qualify the tube shape

11 - Using BENDER SETUP to connect to benders for setup and correction

12 - How to view reports

13 - How to reverse-engineer a tube

14 - Address any unique application needs

15 - Hands-on practice for students

Day 2

1 - Review what we learned on day 1 - quiz the trainees

2 - Practice full corrections loops with actual customer parts

3 - Review special application needs




Other Pages