Difference between revisions of "VTube-LASER Training Agenda"

From ATTWiki
Jump to: navigation, search
(Typical Training Agenda)
(About theTraining Agenda)
Line 20: Line 20:
 
<tr valign=top>
 
<tr valign=top>
 
<td width=500 >
 
<td width=500 >
Training agendas for VTube-LASER usually follow the typical pattern shown below.<br><br>
+
Training agendas for VTube-LASER usually follow the pattern shown below.<br><br>
 
Keep in mind that we adjust the training depending on the customer's application needs. So the agenda shown below may be adjusted if necessary.
 
Keep in mind that we adjust the training depending on the customer's application needs. So the agenda shown below may be adjusted if necessary.
 
<br><br>
 
<br><br>

Revision as of 16:36, 7 September 2017

Vtube-laser logo 1.96.png

Vtl screen hd scanner without logo.png

Contents



About theTraining Agenda

Training agendas for VTube-LASER usually follow the pattern shown below.

Keep in mind that we adjust the training depending on the customer's application needs. So the agenda shown below may be adjusted if necessary.

Typical Training Agenda

VTube-LASER Training Agenda

Day 1

1 - Arm installation and setup

2 - Bender integration assistance (Note: Steps one and 2 may take a few hours)

3 - Probe and scanner calibration

4 - Step through the Quick Start Guide document

5 - Hands-on practice for students

6 - Address any unique application needs - like reverse engineering, assembly, square tubing, etc.



Day 2

1 - Review what we learned on day 1 - quiz the students

2 - Practice full corrections loops with actual customer parts




Other Pages