VTube-LASER Cut Planes

From ATTWiki
Revision as of 22:20, 4 September 2015 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo 1.96.png

Vtube-laser-2.2 cutplane with tube.png



About Cut Planes

Cut planes allow VTube-LASER to define a plane of a table or other surface in order to cut laser points from being used in measurements to VTube-LASER.


How to Create a Cut Plane

Cut planes are created with four measurements with the ball probe.

Cutplane 1234.png

STEP 1

In VTube-LASER click on Measure Process, then click on Measure Cut Plane. The Laser scanner will turn off automatically.

Follow the instructions in the yellow guide box on the left.

Touch the table with the ball probe and press and release the green button.

Vtube-laser cutplane step1.png

STEP 2

Move the probe to another place on table. The further away from the first point, the better for the math engine.

Press and release the green button.

Vtube-laser cutplane step1.png

STEP 3

Select the correct ball probe then press OK.

This step will cause the FARO driver to report back to VTube the new probe. The FARO driver should always remember the last ball probe that you set to "Current Probe" in the pulldown box. This is true even if you shutdown VTube-LASER and the FARO arm.

Vtube-laser v2.2 faro compensation menu.png

STEP 4

Press the Close button in the FARO Arm Utilities window.

Vtube-laser v2.2 armutilities dialog press close.png

STEP 5

Observe that the new ball probe selection will appear in the Arm grid.

Vtube-laser 2.2 measuresetup menu 6mmball.png


Other Pages