Difference between revisions of "VTube-LASER Addata ZModem Communications Protocol"

From ATTWiki
Jump to: navigation, search
(Video of RECALL and SEND)
(Video of RECALL and SEND)
Line 55: Line 55:
 
</td>
 
</td>
 
<td>
 
<td>
[[image:vtube-laser_v2.8.3_AddataZModem Video.png|600px|link=https://www.advancedtubular.com/vtube-laser/vtube-laser_v2.8.3_addata zmodem protocol.mp4]]
+
[[image:vtube-laser_v2.8.3_AddataZModem Video.png|600px|link=https://www.advancedtubular.com/vtube-laser/vtube-laser_v2.8.3_addata_zmodem_protocol.mp4]]
 
</tr>
 
</tr>
 
</table>
 
</table>
 
<br><br>
 
<br><br>

Revision as of 20:00, 24 May 2017

Vtube-laser logo 1.96.png


Addata ZModem Protocol


Addata ZModem Icon Large.png

Contents


About the Addata ZModem Communications Protocol

The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface".

It allows for ZModem file transfer between VTube-LASER and any bender that complies with this protocol. (For example, the Arena software bender controls.)

Vtube-laser v2.8.3 Addata ZModem Send.png

VTube-LASER allows you to setup the COM port configuration to match the configuration at the other end of the serial port connection. Enter System Options, click on the Measure 2 tab, then click on Benderlink. Set the protocol to Addata ZModem, and click on the COM port cell to display this COM port configuration dialog.

Vtube-laser v2.8.3 AddataZModem Benderlink ComSetup.png



Video of RECALL and SEND

Click on the image at the right to see a RECALL/SEND with an Arena Control bender.

Vtube-laser v2.8.3 AddataZModem Video.png