Difference between revisions of "VTube-LASER Addata ZModem Communications Protocol"

From ATTWiki
Jump to: navigation, search
(About the Addata ZModem Communications Protocol)
(About the Addata ZModem Communications Protocol)
Line 27: Line 27:
 
<td width=300>
 
<td width=300>
 
The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface".<br><br>
 
The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface".<br><br>
It allows for ZModem file transfer between VTube-LASER and any bender that complies with this protocol.<br><br>
+
It allows for ZModem file transfer between VTube-LASER and any bender that complies with this protocol. (For example, the Arena Software bender controls.)<br><br>
 
<td>
 
<td>
 
</td>
 
</td>

Revision as of 19:34, 24 May 2017

Vtube-laser logo 1.96.png


Addata ZModem Protocol


Addata ZModem Icon Large.png

Contents


About the Addata ZModem Communications Protocol

The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface".

It allows for ZModem file transfer between VTube-LASER and any bender that complies with this protocol. (For example, the Arena Software bender controls.)

Vtube-laser v2.8.3 Addata ZModem Send.png

VTube-LASER allows you to setup the COM port configuration to match the configuration at the other end of the serial port connection. Enter System Options, click on the Measure 2 tab, then click on Benderlink. Set the protocol to Addata ZModem, and click on the COM port cell to display this COM port configuration dialog.

Vtube-laser v2.8.3 AddataZModem Benderlink ComSetup.png