Difference between revisions of "Using a Datum to Get Print Dimensions"

From ATTWiki
Jump to: navigation, search
(Datum Reports)
(Datum Reports)
Line 60: Line 60:
 
In this example, the two X values show the dimensions that correspond to the 5.5 dimension.<br><br>
 
In this example, the two X values show the dimensions that correspond to the 5.5 dimension.<br><br>
 
The distance values in the report will be distances from the datums that you set in the Datum tab menu in the Master part.<br><br>
 
The distance values in the report will be distances from the datums that you set in the Datum tab menu in the Master part.<br><br>
For example if the tube is a perfect shape, then the X distance should be "4.25" (either positive or negative depending on your master tube's orientation in VTube.) In this example, the X3 value is short by 0.023" along the X axis.  Since the number is green, it is within the tolerance that was previously set in the Inspection menu.<br><br>
+
For example if the tube is a perfect shape, then the X distance should be "4.25" (either positive or negative depending on your master tube's orientation in VTube.) In this example, the X3 value is short by 0.023" along the X axis.  Since the Xdev (deviation) number is green, it is within the tolerance that was previously set in the Inspection menu.<br><br>
 
</td>
 
</td>
 
<td>
 
<td>

Revision as of 14:07, 18 June 2022

Vtube-laser logo 1.96.png


Contents

How to Use Datums To Get Print Dimensions

Vtube-laser v2.7 screenshot.png


Sample Print

This is a sample print with the design intent of checking the width and the height. You can use the VTube-LASER DATUM feature to get to these dimensions.

The diameter of this part is 1.25 inches. You will need to find the X centerline dimension by subtracting 1.25 from 5.5. So - the X dimension should be 5.5 - 1.25 = 4.25.

The Y dimension will be 13 inches - which matches the way VTube-LASER dimensions distances from end to end. No conversion needs to made to that value.

Sampleprint.png



Set the Datum

Set the datum using the Datum tab in the MASTER DATA menu.

It may also be necessary to rotate the master tube into an orientation that is similar to the print. In this case, we used the Transform feature to rotate the master tube so that the first leg is aligned to the Y axis.

Set the datum.png



Datum Reports

After a measure and alignment, use one of the Datum reports in the report menu to show the dimensions.

In this example, the two X values show the dimensions that correspond to the 5.5 dimension.

The distance values in the report will be distances from the datums that you set in the Datum tab menu in the Master part.

For example if the tube is a perfect shape, then the X distance should be "4.25" (either positive or negative depending on your master tube's orientation in VTube.) In this example, the X3 value is short by 0.023" along the X axis. Since the Xdev (deviation) number is green, it is within the tolerance that was previously set in the Inspection menu.

Datumreporttemplate.png

Datumreport1.png

Datumreport2.png



Other Pages