Difference between revisions of "TubeCAD - Blockups With Angles"
From ATTWiki
(→Step 2) |
|||
| Line 11: | Line 11: | ||
*Choose Blockups (in the list on the left) | *Choose Blockups (in the list on the left) | ||
*Calculation Mode (in the properties list on the right) | *Calculation Mode (in the properties list on the right) | ||
| − | *Set the mode to Low Profile with Angles<br> | + | *Set the mode to Low Profile with Angles |
| + | *Click on OK | ||
| + | <br> | ||
[[image:tcad_blockup_withangle3.jpg|400px]] | [[image:tcad_blockup_withangle3.jpg|400px]] | ||
Revision as of 15:11, 26 February 2009
Follow these steps to set blockups to use angles:
Contents |
Start: Blockups without angles
Step 1
Right click and choose Global Layout Settings
Step 2
- Choose Blockups (in the list on the left)
- Calculation Mode (in the properties list on the right)
- Set the mode to Low Profile with Angles
- Click on OK
Modified Blockups
The modified blockups
