Difference between revisions of "The Effect of Changing Cut Length with No Adjustment to the Draw Bender"

From ATTWiki
Jump to: navigation, search
(→‎The Effect)
(→‎The Effect)
Line 18: Line 18:
 
__TOC__
 
__TOC__
  
−
== The Effect ==
+
== What Happens When the Cut Length is Adjusted Without a Corresponding Adjustment to the Carriage Position==
  
 
<table cellpadding=10 width=1000>
 
<table cellpadding=10 width=1000>

Revision as of 14:41, 2 May 2022

Vtube-laser logo 1.96.png



Contents


What Happens When the Cut Length is Adjusted Without a Corresponding Adjustment to the Carriage Position

In a situation where the part shape qualifies and the length on end A qualifies, but the length at end B is LONG, then it is usually still necessary to send a correction to the bender after the user changes the Cut Length on the stick.

The reason is because reducing the cut length will pull the part back into the bender by the amount of the change.

So, if cut length is changed to adjust and correct any part of the tube shape that is not end A, then the starting carriage location must also change. In this case, it must move forward more than it did in the previous set up (when the cut length was longer).

Cut Length Change No Bender Change.png



Retrieved from "http://www.advancedtubular.wiki/index.php?title=The_Effect_of_Changing_Cut_Length_with_No_Adjustment_to_the_Draw_Bender&oldid=41926"