Difference between revisions of "The Effect of Changing Cut Length with No Adjustment to the Draw Bender"
From ATTWiki
(→The Effect) |
(→The Effect) |
||
| Line 25: | Line 25: | ||
In a situation where the part shape qualifies and the length on end A qualifies, but the length at end B is LONG, then it is usually still necessary to send a correction to the bender after the user changes the Cut Length on the stick.<br><br> | In a situation where the part shape qualifies and the length on end A qualifies, but the length at end B is LONG, then it is usually still necessary to send a correction to the bender after the user changes the Cut Length on the stick.<br><br> | ||
The reason is because reducing the cut length will pull the part back into the bender by the amount of the change.<br><br> | The reason is because reducing the cut length will pull the part back into the bender by the amount of the change.<br><br> | ||
| − | So, if cut length is changed to adjust and correct any part of the tube shape that is not end A, then the starting carriage location must also change. In this case, it must move forward.<td> | + | So, if cut length is changed to adjust and correct any part of the tube shape that is not end A, then the starting carriage location must also change. In this case, it must move forward more than it did in the previous set up (when the cut length was longer).<td> |
</td> | </td> | ||
<td> | <td> | ||
| − | [[image:Cut Length Change No Bender Change.png| | + | [[image:Cut Length Change No Bender Change.png|700px]]<br><br> |
</tr> | </tr> | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
Revision as of 14:40, 2 May 2022
|
|
Contents |
The Effect
|
In a situation where the part shape qualifies and the length on end A qualifies, but the length at end B is LONG, then it is usually still necessary to send a correction to the bender after the user changes the Cut Length on the stick. |
|
