Difference between revisions of "The Effect of Changing Cut Length with No Adjustment to the Draw Bender"
From ATTWiki
(Created page with "<table> <tr cellpadding=10> <td width=225> 300px * Back to VTube-LASER * Back to VTube Software Updates (for LASER Mode) </td> ...") |
(→The Effect) |
||
| Line 23: | Line 23: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | In a situation where the part shape qualifies and the length on end A qualifies, but the length at end B is LONG, then it is usually still necessary to correct the bender after you change the Cut Length on the stick to use in bending.<td> | + | In a situation where the part shape qualifies and the length on end A qualifies, but the length at end B is LONG, then it is usually still necessary to correct the bender after you change the Cut Length on the stick to use in bending.<br><br> |
| + | If cut length is changed to adjust and correct any part of the tube shape that is not end A, then the starting carriage location must also change. In this case, it must move forward.<td> | ||
</td> | </td> | ||
<td> | <td> | ||
| Line 31: | Line 32: | ||
</table> | </table> | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
<br><br> | <br><br> | ||
Revision as of 14:37, 2 May 2022
|
|
Contents |
The Effect
|
In a situation where the part shape qualifies and the length on end A qualifies, but the length at end B is LONG, then it is usually still necessary to correct the bender after you change the Cut Length on the stick to use in bending. |
|
VIDEO of RECALL and SEND
| Click on the image on the right to see a RECALL/SEND with an Arena Control bender. |
|
