Difference between revisions of "Setup VTube-LASER for the Network License Manager"

Revision as of 18:27, 12 May 2011

STEP 1

Start the NLM software on the server computer. (See Network License Manager for more information.)

STEP 2

Install the VTube-STEP software. Run VTube-STEP. In System Options, display the General Config tab.

Use the

(Note: Versions earlier than 1.64c use a different set of folders based on the user name.)

Step 3

Do not run VTube during the following steps:

Load the cfg file into an editor like Notepad or Wordpad. Find the [Hardware Key] section:

[Hardware Key]
NLM IP Address=127.0.0.1
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=0
License Type=Laser

Step 4

Change the address to the address of your server IP. (This entry is an example)

[Hardware Key]
NLM IP Address=192.168.0.100
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=0
License Type=Laser

Step 5

Change the Enable Network value to 1.

[Hardware Key]
NLM IP Address=192.168.0.100
Network Timeout=10
Send To NLM Port=17500
Receive From NLM Port=17501
Enable Network=1
License Type=Laser

Step 6

Save and close the cfg file then run VTube.