Safe Mode Cycle Hold

From ATTWiki
Revision as of 22:28, 25 September 2009 by Mcone (Talk | contribs)

Jump to: navigation, search

Cncbender logo.jpg

About the Mode

This mode was introduced by Advanced Tubular Technologies in CNC Bender software combined with SMT benders
(Maybe other benders have this feature - but we have only found others that do not have it.) . It is a Zero Energy State mode when operators step on the safety mat. In this state, all motion axes are completely disabled, and energy to all axes is blocked or stopped.

We strongly recommend that you require this feature for any CNC bender that you consider purchasing. Benders with this feature are much safer than benders without it.

Read about the Zero Energy State on our CNC Benders

Read about Safe Mode Motion Auto Recovery

Gear warning.jpg SAFETY NOTE

The only way to activate Safe Mode Cycle Hold is to either step on the safety mat or walk into the safety scanner region.


If you decide to work on a machine with the pump motor on, then at least step on the safety mat which disables all axes and blocks all hydraulic fluid from flowing to the hydraulic valves.

The only device that can move in this mode is the chuck close and open.