Difference between revisions of "Safe Mode Cycle Hold"
From ATTWiki
| Line 2: | Line 2: | ||
Read more about the [[Zero Energy State]] on our CNC Benders. | Read more about the [[Zero Energy State]] on our CNC Benders. | ||
| − | + | <br><br> | |
<hr> | <hr> | ||
| + | <br><br> | ||
Note: Maybe others have it - but I have only found others that don't. I strongly recommend that you require this feature for any CNC bender that you consider purchasing. Benders with this feature are much safer than benders without it. | Note: Maybe others have it - but I have only found others that don't. I strongly recommend that you require this feature for any CNC bender that you consider purchasing. Benders with this feature are much safer than benders without it. | ||
--[[User:Mcone|Mcone]] 09:59, 1 August 2007 (EDT) | --[[User:Mcone|Mcone]] 09:59, 1 August 2007 (EDT) | ||
Revision as of 14:06, 1 August 2007
This mode is unique (to the best of our knowledge) to CNC Bender software.(see note below) It is a Zero Energy State mode when operators step on the safety mat. In this state, all motion axes are completely disabled, and energy to all axes is blocked or stopped.
Read more about the Zero Energy State on our CNC Benders.
Note: Maybe others have it - but I have only found others that don't. I strongly recommend that you require this feature for any CNC bender that you consider purchasing. Benders with this feature are much safer than benders without it.
--Mcone 09:59, 1 August 2007 (EDT)
