Difference between revisions of "Safe Mode Cycle Hold"

From ATTWiki
Jump to: navigation, search
(About the Mode)
(About the Mode)
Line 7: Line 7:
  
 
Read about the [[Zero Energy State]] on our CNC Benders
 
Read about the [[Zero Energy State]] on our CNC Benders
 +
 +
__NOTOC__
 +
 +
==CYCLE HOLD Button==
 +
<table>
 +
<tr>
 +
<td>Inactive - Button is not illuminated</td>
 +
<td>[[image:cyclehold_inactive.jpg|400px]]</td>
 +
 +
</tr>
 +
 +
<tr>
 +
<td>Active - Button is illuminated</td>
 +
<td>[[image:cyclehold_active.jpg|400px]]</td>
 +
</tr>
 +
 +
</table>
 +
  
 
Read about [[Safe Mode Motion Auto Recovery]]
 
Read about [[Safe Mode Motion Auto Recovery]]

Revision as of 22:29, 25 September 2009

Cncbender logo.jpg

About the Mode

This is a Zero Energy State mode when operators step on the safety mat. In this state, all motion axes are completely disabled, and energy to all axes is blocked or stopped.

We strongly recommend that you require this feature for any CNC bender that you consider purchasing. Benders with this feature are much safer than benders without it.

Read about the Zero Energy State on our CNC Benders


CYCLE HOLD Button

Inactive - Button is not illuminated Cyclehold inactive.jpg
Active - Button is illuminated Cyclehold active.jpg


Read about Safe Mode Motion Auto Recovery

Gear warning.jpg SAFETY NOTE

The only way to activate Safe Mode Cycle Hold is to either step on the safety mat or walk into the safety scanner region.


If you decide to work on a machine with the pump motor on, then at least step on the safety mat which disables all axes and blocks all hydraulic fluid from flowing to the hydraulic valves.

The only device that can move in this mode is the chuck close and open.