Difference between revisions of "Romer"

From ATTWiki
Jump to: navigation, search
Line 6: Line 6:
 
</td>
 
</td>
 
<td>
 
<td>
[[image:ROMER_Scanner_Plus_Hex_Logo.png|500px]]
+
[[image:ROMER_Scanner_Plus_Hex_Logo.png|400px]]
 
</td>
 
</td>
 
</tr>
 
</tr>

Revision as of 19:28, 19 May 2018

As of November of 2017, our VTube-LASER is compatible with any ROMER arm that uses a ball probe and/or laser scanner through the RDS driver.

ROMER Scanner Plus Hex Logo.png

The older ROMER arms were a measuring center company well-known for its Supravision software and portable measuring centers. As of the turn of the century, Romer had begun replacing Supravision with the newer DOCS software.

As of November of 2017, our VTube-LASER is compatible with any ROMER arm that uses a ball probe and/or laser scanner through the RDS driver.

Romer infinite.jpg



Bender Connection using Benderlink Software

  • Our Benderlink Ethernet Module allows Romers with Supravision or DOCS to connect to any VELOG, EL-2000, or Premier Eaton Leonard bender control.
Diagram romer to premier.jpg

Tube Measuring Probes

ROMER arms use infrared probes to measure tube shapes.

The probe shown here is the 25mm probe (also called the 1 inch probe)

Romer tubeprobe.jpg

See the source page for this image.


Calibration Probes

ROMER arms uses ball probes for calibration of the arm.

The probe shown here is the 15mm steel ball probe for calibration of the arm.

Romer 15mmballprobe.jpg


Calibration Bars

This is commonly called a T-Bar.

It is used to calibrate the tube measuring probes.

Romer tbar.jpg