Revision: Benderlink for BLM 3.2

From ATTWiki
Revision as of 04:15, 8 December 2007 by Mcone (Talk | contribs)

Jump to: navigation, search

Benderlink blm logo.jpg

Check.jpg New Recognition of Variable Radius Bending

BLM benders can bend using draw bending or push-bending. BLM refers to push-bending as "variable radius bending." This version of Benderlink can recognize large radius push-bends and skip corrections to straights before and after push-bends. Also the bend angle of each push-bend is left untouched.

Benderlink blm variableradius1.jpg

Benderlink indicates which values are not corrected by showing a bold red value on the screen. The BLUE radius values indicates the Benderlink knows that this is a variable radius bend.

Benderlink blm variableradius2.jpg




Check.jpg Set the Linear Units for Conversion

Benderlink now shows two radio-buttons in the Measuring Center section that allow the operator to send the data to the measuring center in a consistent unit value.

Benderlink blm unitsend.jpg



Check.jpg Adjusted the BLM Data Output Accuracy

Bender data was being output as integer data.

The precision is now set to four places beyond the decimal.



Other Pages

Main Benderlink Wiki page
Main Benderlink for BLM Wiki page