Difference between revisions of "ROMER Certified Length Bar"

From ATTWiki
Jump to: navigation, search
(Certified Length Bars for Checking ROMER Arms)
Line 16: Line 16:
  
  
 +
'''Certified length bars are not included as a STANDARD part of the ROMER Absolute Arm kit. However, they are strongly recommended as an excellent tool to verify that your arm is operating properly. Try to have at least one length bar available in your shop.'''
  
  

Revision as of 23:50, 15 January 2018

Contents

ROMER Certified Length Bar



ROMER Scanner Plus Hex Logo.png


Certified length bars are not included as a STANDARD part of the ROMER Absolute Arm kit. However, they are strongly recommended as an excellent tool to verify that your arm is operating properly. Try to have at least one length bar available in your shop.


Certified Length Bars for Checking ROMER Arms

Certified length bars are good for verifying that your arm is working properly.

The standard length bars use the 15mm calibration probe in one of three sockets.

There are three lengths available:

  1. 305 mm
  2. 711 mm
  3. 1016 mm



For most customers using a 2.5 meter arm, the recommended length bar to purchase is the 711 mm.


ROMERCertifiedLengthBar.png

ROMER RDS Control Panel Probe Quick Check Feature

The ROMER RDS system allows you to easily perform a quick check for the arm with the 15 mm hard probe installed.

The procedure is inside the RDS Control Panel - Probe menu.

RDSControlPanel ProbeCheckEntry.png


Follow the steps to perform a length check.

RDSDataCollectorProbeLengthCheck.png



HEXAGON ACCESSORIES SITE

You can purchase length bars at the HEXAGON site.



Other Pages