Difference between revisions of "Modicon Momentum"
(→I2T IFC220E Servo Modules) |
(→INPUT Base with Ethernet Communication Adapter) |
||
| Line 42: | Line 42: | ||
<td> | <td> | ||
[[image:momentum_serial_port.jpg|300px]] | [[image:momentum_serial_port.jpg|300px]] | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 21:19, 6 May 2010
Contents |
About the Modicon Momentum Package
|
This the form of the modules that are installed to machines that use our CNC Bender software. The different modules come in a variety of functions - but the same packaging. For example, the image here shows an INPUT base with 32-points with an Ethernet Communications Adapter clipped on the top. See this data sheet (16 pages) for an overview of these modules. View the Modicon Momentum I/O Base User Guide (662 pages). They mount to DIN rails in electrical panels. |
|
I2T IFC220E Servo Base or Module
The I2T (Pronounced "I Square T") servo modules use the same package form as the other Modicon products. The base unit contains a computer that can control 2 axes.
|
This is the form for the I2T servo modules with an Ethernet Communications Adapter on the top. You can see a slight difference on the base from the INPUT module with the RJ-45 receptacle. |
|
|
In the I2T servo modules, the serial port is an RJ-45 receptacle port shown in this image. INPUT and OUTPUT modules don't include this port. |
|
OUTPUT Base
| This is an output based. We can use 16 point or 32 point output bases. Generally the 32 point output bases are less expensive per point. |
|
Back of Modicon Momentum I/O Base
| This is the back of the base with a channel for receiving a DIN rail. |
|
Modicon Momentum Analog Base
|
For applications were we must control the positions of proportional valves to set pressures, we output and hold a specific voltage in the +/-10 volt range using the Modicon Momentum Analog base to output up to 4 separate channels. (We can control four valves with one Analog module.)
|
|
Electrical Panel
Most modules are installed in any order convenient in an electrical panel as shown in this example:
This shows a close-up image of INPUT and OUTPUT modules next to each other in the electrical panel.
Other Pages
- Back to CNC Bender page
- Back to CNC Bender General Information page
- Back to CNC Bender Technical Notes page
- General Schneider Electric site for Modicon Momentum bases
