Measuring Center Accessories

From ATTWiki
Revision as of 15:22, 20 June 2012 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-laser logo.jpg Measuring Center Tables

Vtube-laser 1 73.jpg


Newport Integrity 1 VCS, 4 ft. width, 6 ft. length, 6 in. thick, Rigid

This table is highly recommended.

This table was installed for a customer that asked for a turnkey solution. The table is 6" thick. (The other model is 12" thick.) The customer determined that the 6" thick table was better because the final height was 6" lower.

The table top height is 34".

Part Number: INT1-46-6-N
Web site: www.newport.com

Note: We do not recommend the 12" table, as it is 40" from the floor, which makes it too high for some operators.
Newport inegrity.jpg

FARO Magnetic Base

This magnetic base works well on the Newport table.

This is sold through FARO.

Accssories Document (PDF)
Faro magnetic base.jpg

Dell T3500 Desktop

Dell Precision T3500 Minitower Workstation, Intel XEON 3500, Windows 7 Pro, 64 bit, 500 GB hard drive, 12 GB memory

This is one of the fastest computers we have run with the FARO and VTube-LASER.

It was installed as part of a turnkey system at a customer's - and we were told it was the most powerful computer in the entire factory.
Dell T3500.jpg

Dell 24" Flat Panel Monitor

We recommend 24" flat panel monitors as the minimum size for measuring center monitors. This one is a Dell flat panel that we installed with the Dell above. The data on the screen was large and easy to read. Dell 24inchFlatPanel.jpg


Tube Clamp Work Holder

If you want a work holder for the tube for measuring, then we recommend our VTube-LASER Tube Clamp.



Customers will often purchase these in pairs for holding longer tubes.

See the Tube Clamp Web Page for more information.
VTube-LASER TubeClamp.jpg

Other Pages