Difference between revisions of "Master Power On"

From ATTWiki
Jump to: navigation, search
Line 1: Line 1:
Master Power On is the state in which all of the safety stops (E-stops) are cleared and the bender pump is switched on.  
+
Master Power On is the state in which all of the safety stops (E-stops) are cleared and the bender pump is switched on. To switch the Master Power on, clear all the E-stops and safety mechanisms, then press the Master Power On button. In this state, the Master Power On button will illuminate green. If an E-stop, safety mat, or bend-arm safety plate is tripped, then the electronics in the bender will switch the Master Power OFF.
 
+
To switch the Master Power on, clear all the E-stops and safety mechanisms, then press the Master Power On button.
+
 
+
In this state, the Master Power On button will illuminate green.
+
 
+
If an E-stop, safety mat, or bend-arm safety plate is tripped, then the electronics in the bender will switch the Master Power OFF.
+
  
 
See also: [[Can Master Power Be Kept ON by CNC Bender?]]
 
See also: [[Can Master Power Be Kept ON by CNC Bender?]]

Revision as of 02:59, 10 July 2006

Master Power On is the state in which all of the safety stops (E-stops) are cleared and the bender pump is switched on. To switch the Master Power on, clear all the E-stops and safety mechanisms, then press the Master Power On button. In this state, the Master Power On button will illuminate green. If an E-stop, safety mat, or bend-arm safety plate is tripped, then the electronics in the bender will switch the Master Power OFF.

See also: Can Master Power Be Kept ON by CNC Bender?


--Mcone 19:02, 29 June 2006 (EDT)