Difference between revisions of "Master Power On"
From ATTWiki
| (2 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | [[image:cncbender_logo.jpg|400px]] | |
| − | To switch the Master Power on, clear all the E-stops and safety mechanisms, then press the Master Power On button. | + | Master Power On is the state in which all of the safety stops (E-stops) are cleared and the bender pump is switched on. To switch the Master Power on, clear all the E-stops and safety mechanisms, then press the Master Power On button. In this state, the Master Power On button will illuminate green. If an E-stop, safety mat, or bend-arm safety plate is tripped, then the electronics in the bender will switch the Master Power OFF. |
| − | + | See also: [[Can Master Power Be Kept ON by CNC Bender?]] | |
| − | + | ||
| − | + | ||
--[[User:Mcone|Mcone]] 19:02, 29 June 2006 (EDT) | --[[User:Mcone|Mcone]] 19:02, 29 June 2006 (EDT) | ||
Latest revision as of 23:36, 20 September 2007
Master Power On is the state in which all of the safety stops (E-stops) are cleared and the bender pump is switched on. To switch the Master Power on, clear all the E-stops and safety mechanisms, then press the Master Power On button. In this state, the Master Power On button will illuminate green. If an E-stop, safety mat, or bend-arm safety plate is tripped, then the electronics in the bender will switch the Master Power OFF.
See also: Can Master Power Be Kept ON by CNC Bender?
--Mcone 19:02, 29 June 2006 (EDT)
