Difference between revisions of "Master Power On"
From ATTWiki
| Line 6: | Line 6: | ||
If an E-stop, safety mat, or bend-arm safety plate is tripped, then the electronics in the bender will switch the Master Power OFF. | If an E-stop, safety mat, or bend-arm safety plate is tripped, then the electronics in the bender will switch the Master Power OFF. | ||
| + | |||
| + | See also: [[Can Master Power Be Kept ON by CNC Bender?]] | ||
--[[User:Mcone|Mcone]] 19:02, 29 June 2006 (EDT) | --[[User:Mcone|Mcone]] 19:02, 29 June 2006 (EDT) | ||
Revision as of 23:08, 29 June 2006
Master Power On is the state in which all of the safety stops (E-stops) are cleared and the bender pump is switched on.
To switch the Master Power on, clear all the E-stops and safety mechanisms, then press the Master Power On button.
In this state, the Master Power On button will illuminate green.
If an E-stop, safety mat, or bend-arm safety plate is tripped, then the electronics in the bender will switch the Master Power OFF.
See also: Can Master Power Be Kept ON by CNC Bender?
--Mcone 19:02, 29 June 2006 (EDT)
