Difference between revisions of "Inspection Tolerances"
From ATTWiki
(→Angular) |
(→Radial) |
||
| Line 26: | Line 26: | ||
<td width=300> | <td width=300> | ||
===Radial=== | ===Radial=== | ||
| − | + | '''This value changes the tolerance the shape of the tube is qualified to.</td> | |
<td> | <td> | ||
[[image:vtubeinspectiondata.png|700px]] | [[image:vtubeinspectiondata.png|700px]] | ||
| Line 33: | Line 33: | ||
<tr> | <tr> | ||
<td width=300> | <td width=300> | ||
| + | |||
===Linear=== | ===Linear=== | ||
'''This value effects the ends of the tube.'''<br><br> Change the value and press F2 on the keyboard or Refresh Parametrics in the upper right hand cornder of VTube</td> | '''This value effects the ends of the tube.'''<br><br> Change the value and press F2 on the keyboard or Refresh Parametrics in the upper right hand cornder of VTube</td> | ||
Revision as of 15:22, 20 February 2023
|
|
|
Different Tolerances
The tolerances inside the Inspection Tab can be adjusted to qualify parts to different standards.
RadialThis value changes the tolerance the shape of the tube is qualified to. |
|
LinearThis value effects the ends of the tube.Change the value and press F2 on the keyboard or Refresh Parametrics in the upper right hand cornder of VTube |
|
AngularThis value effects the angle tolerance. |
|
|
|
