Importing a .STP File

From ATTWiki
Revision as of 21:00, 16 February 2023 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-step logo 1.96.png


This document shows the process of importing a STEP file into VTube-STEP

The files used are .stp files.

Steps to import a .stp file into VTube-STEP

STEP 1

Make sure VTube-STEP is cleared.

Vtube-v4 CLEARED.png

STEP 2

Under Import/Export, import a STEP File-STP.

Vtube-v4 import.png

STEP 3

Load the desired part into VTube-STEP from the file it is saved in inside file explorer

Vtube v4demo6.png

STEP 4

To collect parametric data, an operator can either autobuild or manually collect features.

For Autobuild

For Manual Collection

Vtube v4autobuild.png


STEP 5

  • Rebuild Parametric Tube from Collected if manual collection was used

Vtube-STEP v4rebuild.png

STEP 6

The XYZ and LRA grid will now have parametric data in them. This information can be sent to a bender, or brought into VTube-LASER to be measured against.

Vtube-v4parametric.png

STEP 7

Save the .CHS file to the same thumb drive, remove it and take it back to the bender

Vtube v3.2 ATTUSB.png

STEP 8

Load the file in the bender and bend the part. Make sure to double check the data in VTube-STEP matches the data in the bender.

Vtube v2.2 chiyodacontrol.png


Other Pages