How to Setup for Supravision Network Protocol

From ATTWiki
Revision as of 18:41, 12 September 2012 by Mcone (Talk | contribs)

Jump to: navigation, search

Blinkellogo.jpg



How to setup the SVNET protocol with Benderlink for EL.

Blinkel v4-20080909 mainscreen.jpg


Contents

Step 1: Enter the Benderlink Network

Open the Tools > Configure Benderlink Network Menu

BlinkEL Tools ConfigureBenderlinkNetwork Menu.jpg


Step 2: Enter the Benderlink Network

Press the Bender Network tab, then select the bender you want to edit (or add one), then press "Edit".

BlinkEL BenderNetwork.jpg


Step 3: Setup the Bender Communication Parameters

  • Each bender number must be unique.
  • The name will display in the user interface of Benderlink.
  • The COM port is the port number assigned to communicate with this bender.
  • Press OK.

BlinkEL EditBenderNetwork.jpg


Step 4: Switch to the Measuring Center Name Tab Menu

Set the name of the measuring center to one of the types that uses the Supravision Network protocol.

BlinkEL MeasuringCenterName.jpg


Step 5: Switch to the Measuring Center Protocol Tab Menu

Set the name of the measuring center protocol to "Supravision Network".

BlinkEL MeasuringCenterProtocol.jpg


Step 6: Switch to the Supravision Tab Menu

  • Set the monitor frequency from 2 to 5 seconds
  • Set the max benders to scan (set to your highest bender number)
  • Set the Supravision Network path that Supravision uses to drop SVNET files.
  • Enable the Monitor for SV Commands checkbox

BlinkEL Supravision.jpg


Step 7: Press OK to Exit the Window

The main window will change to show the Measuring Center setup:

BlinkEL MainWindow MeasuringCenter.jpg


Benderlink is now ready to communicate automatically with the EL benders programmed into your network.


=Other Pages