Difference between revisions of "How to Setup for Supravision Network Protocol"

From ATTWiki
Jump to: navigation, search
(Step 7: Press OK to Exit the Window)
Line 77: Line 77:
  
  
Benderlink is now ready to communicate automatically with the EL benders programmed into your network.
+
Benderlink is now ready to communicate automatically with the EL benders programmed into your network. The Monitor Status LED will switch on and off indicating that it is watching for measuring center commands.
 
+
 
+
  
 
==Other Pages=
 
==Other Pages=
  
 
*Back to [[Benderlink for Eaton Leonard]]
 
*Back to [[Benderlink for Eaton Leonard]]

Revision as of 18:42, 12 September 2012

Blinkellogo.jpg



How to setup the SVNET protocol with Benderlink for EL.

Blinkel v4-20080909 mainscreen.jpg


Contents

Step 1: Enter the Benderlink Network

Open the Tools > Configure Benderlink Network Menu

BlinkEL Tools ConfigureBenderlinkNetwork Menu.jpg


Step 2: Enter the Benderlink Network

Press the Bender Network tab, then select the bender you want to edit (or add one), then press "Edit".

BlinkEL BenderNetwork.jpg


Step 3: Setup the Bender Communication Parameters

  • Each bender number must be unique.
  • The name will display in the user interface of Benderlink.
  • The COM port is the port number assigned to communicate with this bender.
  • Press OK.

BlinkEL EditBenderNetwork.jpg


Step 4: Switch to the Measuring Center Name Tab Menu

Set the name of the measuring center to one of the types that uses the Supravision Network protocol.

BlinkEL MeasuringCenterName.jpg


Step 5: Switch to the Measuring Center Protocol Tab Menu

Set the name of the measuring center protocol to "Supravision Network".

BlinkEL MeasuringCenterProtocol.jpg


Step 6: Switch to the Supravision Tab Menu

  • Set the monitor frequency from 2 to 5 seconds
  • Set the max benders to scan (set to your highest bender number)
  • Set the Supravision Network path that Supravision uses to drop SVNET files.
  • Enable the Monitor for SV Commands checkbox

BlinkEL Supravision.jpg


Step 7: Press OK to Exit the Window

The main window will change to show the Measuring Center setup:

BlinkEL MainWindow MeasuringCenter.jpg


Benderlink is now ready to communicate automatically with the EL benders programmed into your network. The Monitor Status LED will switch on and off indicating that it is watching for measuring center commands.

=Other Pages