Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Blue Columns With Actual Bender Control Values) |
(→Blue Columns After Bender Values Entered) |
||
Line 54: | Line 54: | ||
* To copy the Master data, use the "COPY Master LRA to Setup LRA" button.<br><br> | * To copy the Master data, use the "COPY Master LRA to Setup LRA" button.<br><br> | ||
* To enter actual data from the bender, either press the RECALL LRA from BENDER if your bender has a connection, or enter the data in the blue columns manually.<br><br> | * To enter actual data from the bender, either press the RECALL LRA from BENDER if your bender has a connection, or enter the data in the blue columns manually.<br><br> | ||
+ | * Note that filling the blue columns with values will have an impact on correction reports.<br><br> | ||
[[image:vtube_benderdatasetup_bluecol_nonzeros.jpg|600px]] | [[image:vtube_benderdatasetup_bluecol_nonzeros.jpg|600px]] | ||
Revision as of 05:24, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrect/Correct Setup of Bender Data
Other Pages
- Back to VTube-LASER