Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Example Effect on Report with Incorrectly Setup Bender Data) |
(→Example Effect on Report with Incorrectly Setup Bender Data) |
||
Line 90: | Line 90: | ||
<tr> | <tr> | ||
<td> | <td> | ||
− | LENGTHS | + | LENGTHS incorrectly set to all ZEROS: |
[[image:vtube_benderdatasetup_bluelengthzero_example.jpg]] | [[image:vtube_benderdatasetup_bluelengthzero_example.jpg]] | ||
</td> | </td> | ||
<td> | <td> | ||
− | LENGTHS with real values: | + | LENGTHS correctly set with real values: |
[[image:vtube_benderdatasetup_bluelengthnonzero_example.jpg]] | [[image:vtube_benderdatasetup_bluelengthnonzero_example.jpg]] | ||
</td> | </td> |
Revision as of 04:43, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. It is critical to enter the Bender Data Setup menu to be sure that the blue column values match the current bender setup BEFORE BUILDING REPORTS.
|
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrectly Setup Bender Data
Other Pages
- Back to VTube-LASER