Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Blue Columns Starts With All Zeros) |
(→Blue Columns With Actual Bender Control Values) |
||
Line 50: | Line 50: | ||
[[image:vtube_benderdatasetup_bluecol_zeros.jpg|600px]]<br><br> | [[image:vtube_benderdatasetup_bluecol_zeros.jpg|600px]]<br><br> | ||
− | ===Blue Columns | + | ===Blue Columns After Bender Values Entered=== |
Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.<br><br> | Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.<br><br> | ||
* To copy the Master data, use the "COPY Master LRA to Setup LRA" button.<br><br> | * To copy the Master data, use the "COPY Master LRA to Setup LRA" button.<br><br> |
Revision as of 05:23, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrect/Correct Setup of Bender Data
Other Pages
- Back to VTube-LASER