Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Blue Columns With All Zeros) |
(→Blue Columns Starts With All Zeros) |
||
Line 46: | Line 46: | ||
VTube builds the adjusted bender data in the reports using the blue columns in the Bender Data Setup menu - not the MASTER LRA data. '''So this step is important even when you are not the Bender Data Setup menu to communicate with the bender.'''<br><br> | VTube builds the adjusted bender data in the reports using the blue columns in the Bender Data Setup menu - not the MASTER LRA data. '''So this step is important even when you are not the Bender Data Setup menu to communicate with the bender.'''<br><br> | ||
− | ===Blue Columns | + | ===Blue Columns Start With All Zeros=== |
In this example, the tube has been inspected, '''the but the blue columns are still set to zero''' (see below). The blue columns contain the values that the bender will have before correction. So if the blue columns are all zeros, then the reports will show bender data setup as all zeros + adjustments.<br><br> | In this example, the tube has been inspected, '''the but the blue columns are still set to zero''' (see below). The blue columns contain the values that the bender will have before correction. So if the blue columns are all zeros, then the reports will show bender data setup as all zeros + adjustments.<br><br> | ||
[[image:vtube_benderdatasetup_bluecol_zeros.jpg|600px]]<br><br> | [[image:vtube_benderdatasetup_bluecol_zeros.jpg|600px]]<br><br> |
Revision as of 05:22, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrect/Correct Setup of Bender Data
Other Pages
- Back to VTube-LASER