Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→STEP 1 - Measure and Align) |
|||
Line 38: | Line 38: | ||
</tr> | </tr> | ||
</table> | </table> | ||
+ | <br><br> | ||
==STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu== | ==STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu== |
Revision as of 05:22, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrect/Correct Setup of Bender Data
Other Pages
- Back to VTube-LASER