Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Explanation of Why The Values Are Not Negative) |
|||
Line 15: | Line 15: | ||
<table> | <table> | ||
<tr cellpadding=10> | <tr cellpadding=10> | ||
− | <td width= | + | <td width=500> |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu.<br><br> | When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu.<br><br> | ||
Therefore, '''it is critical to enter the Bender Data Setup menu to be sure that the blue column values match the current bender setup before building reports.''' | Therefore, '''it is critical to enter the Bender Data Setup menu to be sure that the blue column values match the current bender setup before building reports.''' | ||
Line 21: | Line 21: | ||
Here is how to use this principle: | Here is how to use this principle: | ||
</td> | </td> | ||
− | <td width= | + | <td width=500> |
</td> | </td> | ||
</tr> | </tr> |
Revision as of 05:21, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrect/Correct Setup of Bender Data
Other Pages
- Back to VTube-LASER