Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Correct Setup Example) |
(→Explanation of Example Effect) |
||
Line 117: | Line 117: | ||
===Explanation of Example Effect=== | ===Explanation of Example Effect=== | ||
− | + | ||
* VTube uses a rule that will not allow a length or bend angle to go negative.<br><br> | * VTube uses a rule that will not allow a length or bend angle to go negative.<br><br> | ||
* So it believes (incorrectly) that lengths 2, 3, and 7 will become negative if adjustment is applied. Therefore VTube substitutes zeros in place of the negative values. (The same rule applies to bend angles - but not rotation angles.)<br><br> | * So it believes (incorrectly) that lengths 2, 3, and 7 will become negative if adjustment is applied. Therefore VTube substitutes zeros in place of the negative values. (The same rule applies to bend angles - but not rotation angles.)<br><br> |
Revision as of 05:19, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrect/Correct Setup of Bender Data
Other Pages
- Back to VTube-LASER