Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Report Chart with Incorrect Values) |
(→Correct Setup Example) |
||
Line 102: | Line 102: | ||
<tr> | <tr> | ||
<td> | <td> | ||
− | The blue columns | + | The blue columns in this grid use non-zero data that is programmed into the bender control. This is an example of correct setup.<br><br> |
</td> | </td> | ||
<td> | <td> | ||
Line 110: | Line 110: | ||
</tr> | </tr> | ||
</table> | </table> | ||
− | |||
===Example Report Chart Generated With Incorrect Values=== | ===Example Report Chart Generated With Incorrect Values=== |
Revision as of 05:19, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrect/Correct Setup of Bender Data
Other Pages
- Back to VTube-LASER