Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Incorrect Setup Example) |
(→Example Effect on Report with Incorrect/Correct Setup of Bender Data) |
||
Line 112: | Line 112: | ||
− | + | ===Report Chart with Incorrect Values=== | |
This is a screen image of a chart based on the values from the left grid above. Lengths (2,3, and 7) should be adjusted negative - but are not. | This is a screen image of a chart based on the values from the left grid above. Lengths (2,3, and 7) should be adjusted negative - but are not. | ||
[[image:vtube_report_withbenderata_allzeros.jpg|600px]]<br><br> | [[image:vtube_report_withbenderata_allzeros.jpg|600px]]<br><br> |
Revision as of 05:18, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrect/Correct Setup of Bender Data
Other Pages
- Back to VTube-LASER