Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Example Effect on Report with Incorrectly Setup Bender Data) |
(→Incorrect Setup Example) |
||
Line 89: | Line 89: | ||
<tr> | <tr> | ||
<td> | <td> | ||
− | + | The blue column values in this grid (from the Bender Data Setup menu) are set to zero - which means VTube believes that the bender is setup with all zero lengths between bends. The left grid is an example of an incorrect setup. | |
</td> | </td> | ||
<td> | <td> |
Revision as of 05:17, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrect/Correct Setup of Bender Data
Other Pages
- Back to VTube-LASER