Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Example Effect on Report with Incorrectly Setup Bender Data) |
(→Example Effect on Report with Incorrectly Setup Bender Data) |
||
Line 80: | Line 80: | ||
<br><br> | <br><br> | ||
− | ==Example Effect on Report with | + | ==Example Effect on Report with Incorrect/Correct Setup of Bender Data== |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> |
Revision as of 05:16, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrect/Correct Setup of Bender Data
Other Pages
- Back to VTube-LASER