Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Example Effect on Report with Incorrectly Setup Bender Data) |
(→Example Effect on Report with Incorrectly Setup Bender Data) |
||
Line 85: | Line 85: | ||
<td width=500> | <td width=500> | ||
+ | ===Incorrect Setup Example=== | ||
<table cellspacing=10> | <table cellspacing=10> | ||
<tr> | <tr> | ||
<td> | <td> | ||
− | Examine screen | + | Examine screen image of the grid setup in the Bender Data Setup menu (see right). The blue column values in the grid are set to zero - which means VTube believes that the bender is setup with all zero lengths between bends. The left grid is an example of an incorrect setup. |
</td> | </td> | ||
<td> | <td> | ||
Line 97: | Line 98: | ||
</table> | </table> | ||
− | + | ===Correct Setup Example=== | |
<table cellspacing=10> | <table cellspacing=10> | ||
<tr> | <tr> | ||
<td> | <td> | ||
− | The blue columns on | + | The blue columns on this grid use non-zero data that is programmed into the bender control. This is an example of correct setup.<br><br> |
</td> | </td> | ||
<td> | <td> |
Revision as of 05:16, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrectly Setup Bender Data
Other Pages
- Back to VTube-LASER