Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Example Effect on Report with Incorrectly Setup Bender Data) |
(→Explanation) |
||
Line 108: | Line 108: | ||
[[image:vtube_report_withbenderata_allzeros.jpg|600px]]<br><br> | [[image:vtube_report_withbenderata_allzeros.jpg|600px]]<br><br> | ||
− | ===Explanation=== | + | ===Explanation of Example Effect=== |
* This chart looks like an adjustment chart - but it is NOT just adjustments alone. It is the current '''bender data''' plus adjustments. So VTube believes that the bender data in the bender control is set to all ZEROS.<br><br> | * This chart looks like an adjustment chart - but it is NOT just adjustments alone. It is the current '''bender data''' plus adjustments. So VTube believes that the bender data in the bender control is set to all ZEROS.<br><br> |
Revision as of 05:13, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrectly Setup Bender Data
Other Pages
- Back to VTube-LASER