Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu) |
(→STEP 3 - Exit the Bender Data Setup Menu to Display Reports) |
||
Line 69: | Line 69: | ||
Now the reports can be displayed with the corrected bender data that is in the Bender Data Setup menu. Exit the menu and preview any report with correction data.<br><br> | Now the reports can be displayed with the corrected bender data that is in the Bender Data Setup menu. Exit the menu and preview any report with correction data.<br><br> | ||
− | Examine the report chart here to see how | + | Examine the report chart here to see how the Bender Data Setup values are carried into the report for this change (Bender + Adjusted). See the ORANGE columns in the image in the previous step to compare values.<br><br> |
[[image:vtube_report_withbenderata.jpg|600px]]<br><br> | [[image:vtube_report_withbenderata.jpg|600px]]<br><br> | ||
Revision as of 05:11, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrectly Setup Bender Data
Other Pages
- Back to VTube-LASER