Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
Line 17: | Line 17: | ||
<td width=300> | <td width=300> | ||
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu.<br><br> | When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu.<br><br> | ||
− | Therefore, '''it is critical to enter the Bender Data Setup menu to be sure that the blue column values match the current bender setup | + | Therefore, '''it is critical to enter the Bender Data Setup menu to be sure that the blue column values match the current bender setup before building reports.''' |
<br><br> | <br><br> | ||
Here is how to use this principle: | Here is how to use this principle: |
Revision as of 05:06, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. |
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrectly Setup Bender Data
Other Pages
- Back to VTube-LASER