Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Example Effect on Report with Incorrectly Setup Bender Data) |
(→Example Effect on Report with Incorrectly Setup Bender Data) |
||
Line 82: | Line 82: | ||
<td width=500> | <td width=500> | ||
− | Examine screen images of the two grid setups in the Bender Data Setup menu (see below). The blue column values on the left are set to zero - which means VTube believes that the bender is setup with all zero lengths between bends. | + | Examine screen images of the two grid setups in the Bender Data Setup menu (see below). The blue column values on the left are set to zero - which means VTube believes that the bender is setup with all zero lengths between bends. The left grid is an example of an incorrect setup.<br><br> |
+ | The blue columns on the right grid use non-zero data that is programmed into the bender control. This is an example of correct setup.<br><br> | ||
Revision as of 04:42, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. It is critical to enter the Bender Data Setup menu to be sure that the blue column values match the current bender setup BEFORE BUILDING REPORTS.
|
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrectly Setup Bender Data
Other Pages
- Back to VTube-LASER