Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu) |
|||
Line 49: | Line 49: | ||
Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.<br><br> | Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.<br><br> | ||
* To copy the Master data, use the "COPY Master LRA to Setup LRA" button.<br><br> | * To copy the Master data, use the "COPY Master LRA to Setup LRA" button.<br><br> | ||
− | * To enter actual data from the bender, either press the RECALL LRA from BENDER if your bender has a connection, or | + | * To enter actual data from the bender, either press the RECALL LRA from BENDER if your bender has a connection, or enter the data in the blue columns manually.<br><br> |
[[image:vtube_benderdatasetup_bluecol_nonzeros.jpg|600px]] | [[image:vtube_benderdatasetup_bluecol_nonzeros.jpg|600px]] | ||
Revision as of 04:30, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. It is critical to enter the Bender Data Setup menu to be sure that the blue column values match the current bender setup BEFORE BUILDING REPORTS.
|
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Adjust the Blue Columns in the Bender Data Setup Menu
STEP 3 - Exit the Bender Data Setup Menu to Display Reports
Example Effect on Report with Incorrectly Setup Bender Data
Other Pages
- Back to VTube-LASER