Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Other Pages) |
(→STEP 4 - Exit the Bender Data Setup Menu to Display Reports) |
||
Line 73: | Line 73: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=500> | <td width=500> | ||
− | Now the reports can be displayed with the corrected bender data that is in the Bender Data Setup menu. | + | Now the reports can be displayed with the corrected bender data that is in the Bender Data Setup menu. Exit the menu and preview any report with correction data.<br><br> |
− | Exit the menu and preview any report with correction data.<br><br> | + | |
This is the Bender Data Setup for the Length values:<br><br> | This is the Bender Data Setup for the Length values:<br><br> |
Revision as of 04:16, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
Contents |
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. It is critical to entering the Bender Data Setup menu to be sure that the blue column values match the current bender setup BEFORE BUILDING REPORTS.
|
STEP 1 - Measure and Align
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Enter the Bender Data Setup Menu
STEP 3 - Establish Current Bender Values in the Blue Columns
Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.
|
STEP 4 - Exit the Bender Data Setup Menu to Display Reports
Example Report with INCORRECT Data
Other Pages
- Back to VTube-LASER