Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→Example Report with INCORRECT Data) |
|||
Line 13: | Line 13: | ||
__NOTOC__ | __NOTOC__ | ||
− | When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. | + | When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. '''It is critical to entering the Bender Data Setup menu to be sure that the blue column values match the current bender setup BEFORE BUILDING REPORTS.''' |
<br><br> | <br><br> | ||
Here is how to use this principle: | Here is how to use this principle: |
Revision as of 04:13, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
When building reports with bender data plus adjustment data, it is important to remember that the report builder gets the bender data from the Bender Data Setup menu. It is critical to entering the Bender Data Setup menu to be sure that the blue column values match the current bender setup BEFORE BUILDING REPORTS.
Here is how to use this principle:
STEP 1 - Measure and Align the Measured Tube with the Master
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Enter the Bender Data Setup Menu
STEP 3 - Establish Current Bender Values in the Blue Columns
Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.
|
STEP 4 - Exit the Bender Data Setup Menu to Display Reports
Example Report with INCORRECT Data
Other Pages
- Back to VTube-LASER