Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→STEP 3 - Establish Current Bender Values in the Blue Columns) |
(→STEP 3 - Establish Current Bender Values in the Blue Columns) |
||
Line 49: | Line 49: | ||
* To enter actual data from the bender, either press the RECALL LRA from BENDER if your bender has a connection, or printout and enter the data in the blue columns manually.<br><br> | * To enter actual data from the bender, either press the RECALL LRA from BENDER if your bender has a connection, or printout and enter the data in the blue columns manually.<br><br> | ||
[[image:vtube_benderdatasetup_bluecol_nonzeros.jpg|600px]] | [[image:vtube_benderdatasetup_bluecol_nonzeros.jpg|600px]] | ||
+ | </td> | ||
+ | <td width=300> | ||
+ | </td> | ||
+ | </tr> | ||
+ | </table> | ||
+ | |||
+ | <br><br> | ||
+ | |||
+ | |||
+ | ===STEP 4 - Exit the Bender Data Setup Menu to Display Reports=== | ||
+ | <table cellpadding=10> | ||
+ | <tr valign=top> | ||
+ | <td width=500> | ||
+ | Now the reports can be displayed with the corrected bender data that is in the Bender Data Setup menu.<br><br> | ||
+ | Exit the menu and preview any report with correction data.<br><br> | ||
+ | This is an example of a report with Bender + Adjusted that has been setup properly in the Bender Data Setup menu: | ||
+ | [[image:vtube_report_withbenderata.jpg|600px]]<br><br> | ||
+ | This is an example of a report with Bender + Adjusted where the BENDER data is set to all zeros in the Bender Data Setup menu: | ||
+ | [[image:vtube_report_withbenderata_allzeros.jpg|600px]]<br><br> | ||
+ | |||
+ | The problem with using the second chart for corrections with damping is that damping will not allow a length or bend angle to enter the negative region. If VTube finds any value at ZERO, and an adjustment takes it in to the negative region, then VTube will show ZERO for Bender data + Adjusted - which is not correct. | ||
+ | |||
</td> | </td> | ||
<td width=300> | <td width=300> |
Revision as of 03:44, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
STEP 1 - Measure and Align the Measured Tube with the Master
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Enter the Bender Data Setup Menu
STEP 3 - Establish Current Bender Values in the Blue Columns
Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.
|
STEP 4 - Exit the Bender Data Setup Menu to Display Reports
Other Pages
- Back to VTube-LASER