Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→STEP 3 - Establish Non-zero Values in the Blue Columns) |
(→STEP 2 - Enter the Bender Data Setup Menu) |
||
Line 32: | Line 32: | ||
This is an important step that for building good adjustment reports. Remember that VTube gets the bender setup data in the reports from the blue columns in the Bender Data Setup menu - not the MASTER LRA data. '''So this step is important even when you are not using this menu to communicate with the bender.'''<br><br> | This is an important step that for building good adjustment reports. Remember that VTube gets the bender setup data in the reports from the blue columns in the Bender Data Setup menu - not the MASTER LRA data. '''So this step is important even when you are not using this menu to communicate with the bender.'''<br><br> | ||
In this example, the tube has been inspected, '''the but the blue columns are still set to zero''' (see below). The blue columns contain the values that the bender will have before correction. So if the blue columns are all zeros, then the reports will show bender data setup as all zeros + adjustments.<br><br> | In this example, the tube has been inspected, '''the but the blue columns are still set to zero''' (see below). The blue columns contain the values that the bender will have before correction. So if the blue columns are all zeros, then the reports will show bender data setup as all zeros + adjustments.<br><br> | ||
− | [[image:vtube_benderdatasetup_bluecol_zeros.jpg| | + | [[image:vtube_benderdatasetup_bluecol_zeros.jpg|600px]] |
</td> | </td> | ||
<td width=300> | <td width=300> |
Revision as of 03:39, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
STEP 1 - Measure and Align the Measured Tube with the Master
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Enter the Bender Data Setup Menu
STEP 3 - Establish Current Bender Values in the Blue Columns
Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.
|
Other Pages
- Back to VTube-LASER