Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→STEP 2 - Enter the Bender Data Setup Menu) |
(→STEP 3 - COPY Master LRA to Setup LRA) |
||
Line 41: | Line 41: | ||
<br><br> | <br><br> | ||
− | ===STEP 3 - | + | ===STEP 3 - Establish Non-zero Values in the Blue Columns== |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=500> | <td width=500> | ||
Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.<br><br> | Fill the blue columns with data either from the MASTER (initial setup), or the actual data used in the bender.<br><br> | ||
+ | To copy the Master data, use the "COPY Master LRA to Setup LRA" button.<br><br> | ||
To enter actual data from the bender, either press the RECALL LRA from BENDER if your bender has a connection, or printout and enter the data in the blue columns manually.<br><br> | To enter actual data from the bender, either press the RECALL LRA from BENDER if your bender has a connection, or printout and enter the data in the blue columns manually.<br><br> | ||
[[image:vtube_benderdatasetup_bluecol_nonzeros.jpg|700px]] | [[image:vtube_benderdatasetup_bluecol_nonzeros.jpg|700px]] |
Revision as of 03:36, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
STEP 1 - Measure and Align the Measured Tube with the Master
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Enter the Bender Data Setup Menu
=STEP 3 - Establish Non-zero Values in the Blue Columns
Other Pages
- Back to VTube-LASER