Difference between revisions of "How to Setup Reports to Show Bender Plus Adjusted Data"
From ATTWiki
(→STEP 2 - Enter the Bender Data Setup Menu) |
(→STEP 1 - Measure and Align the Measured Tube with the Master) |
||
Line 19: | Line 19: | ||
<td width=500> | <td width=500> | ||
Enter the MASTER data, then measure and align the measured tube to the master data.<br><br> | Enter the MASTER data, then measure and align the measured tube to the master data.<br><br> | ||
− | [[image:vtube_3mm_inspection.jpg| | + | [[image:vtube_3mm_inspection.jpg|700px]] |
</td> | </td> | ||
<td width=300> | <td width=300> |
Revision as of 03:34, 22 September 2012
Setup VTube-LASER Reports to Show Bender Plus Adjusted Data
|
STEP 1 - Measure and Align the Measured Tube with the Master
Enter the MASTER data, then measure and align the measured tube to the master data. |
STEP 2 - Enter the Bender Data Setup Menu
STEP 3 - COPY Master LRA to Setup LRA
Other Pages
- Back to VTube-LASER